Shop by category
Shop all componentsWiring & PCB
Drop is above your limit. Use thicker wire, a shorter run, or a higher supply voltage.
R = ρ × 2L ÷ AV drop = I × RA min = I × ρ × 2L ÷ (V × max %)12 V, 5 A over 5 m of 1.5 mm² copper: R = 1.724×10⁻⁸ × 10 ÷ 1.5×10⁻⁶ = 0.115 Ω, so the drop is 0.57 V (4.8%) and 2.9 W heats the cable. 2.5 mm² keeps it under 3%.
Current has to go out and come back, so the cable length counts twice. At low voltages even a fraction of a volt matters: a 5 V device at the end of a long thin cable may brown out, and LED strips change colour.
Keep the drop below about 3% for electronics and 5% for motors and lighting. If the required wire is impractically thick, raise the supply voltage and step down near the load with a buck converter; quadrupling the voltage cuts the current, and the losses, dramatically.
Aim for under 3 % on power runs and under 5 % at most. On 12 V that is 0.36 V to 0.6 V.
Current flows out and back, so the total copper length is twice the cable run.
Use thicker wire, shorten the run or use a higher supply voltage with a converter at the load.
R = ρ × 2L ÷ A; V drop = I × R; A min = I × ρ × 2L ÷ (V × max %).
12 V, 5 A over 5 m of 1.5 mm² copper: R = 1.724×10⁻⁸ × 10 ÷ 1.5×10⁻⁶ = 0.115 Ω, so the drop is 0.57 V (4.8%) and 2.9 W heats the cable. 2.5 mm² keeps it under 3%.
Geekobot builds that use it include Dashboard battery voltmeter for cars and bikes, Car cabin air-quality meter, Two-wheeler side-stand warning and Solder a fused 12 V to 5 V power board on stripboard. Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators