Shop by category
Shop all componentsWiring & PCB
Nichrome 80/20 wire (resistivity about 1.1 µΩ·m). Wire runs hot: keep it away from plastic and flammable material, and use a current-limited supply.
R = V² ÷ PLength = R × A ÷ ρA = π ÷ 4 × d², ρ ≈ 1.10 × 10⁻⁶ Ω·mA 12 V, 30 W heater needs R = 144 ÷ 30 = 4.8 Ω. With 28 AWG nichrome (0.321 mm, 13.6 Ω per metre) that is 0.353 m of wire, current 2.5 A.
Nichrome is an alloy with high resistance and a high melting point, so it glows and gets hot when current flows. Pick a wire gauge that gives a practical length, then cut it to the length that gives the resistance you need for the power you want.
Thicker wire needs a longer length and runs cooler at the same power; thinner wire gets hotter for the same watts per metre. Hot-wire foam cutters typically use 26–30 AWG and a variable power supply, so you can tune the temperature.
R = V² ÷ P, then length = R × area ÷ resistivity. The calculator works it out for your wire gauge.
It depends on power per length and airflow. Foam cutters run at a dull glow.
Yes, if the wire length gives a current within the adapter rating.
R = V² ÷ P; Length = R × A ÷ ρ; A = π ÷ 4 × d², ρ ≈ 1.10 × 10⁻⁶ Ω·m.
A 12 V, 30 W heater needs R = 144 ÷ 30 = 4.8 Ω. With 28 AWG nichrome (0.321 mm, 13.6 Ω per metre) that is 0.353 m of wire, current 2.5 A.
Geekobot builds that use it include Diya flicker LED strip for Diwali, Grow light that tops up daylight, LED strip scanner with speed knob and Diwali and festival light patterns. Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators