Shop by category
Shop all componentsWiring & PCB
The fuse’s voltage rating must be at least the circuit voltage, and DC fuses are different from AC fuses. Fuse the positive wire as close to the battery as possible.
Minimum fuse = load current × marginPick the next standard ratingFuse rating ≤ wire current ratingAn 8 A steady load with a 1.25× margin needs 10 A, so use a 10 A fuse. 18 AWG wire can carry 16 A in short chassis wiring, so the wire is protected.
A fuse protects the wire, not the device: it must blow before the wire overheats. So the fuse rating must be above the normal load current, but below the wire’s safe rating.
For motors and incandescent lamps, use a slow-blow (time-delay) fuse so the switch-on surge does not blow it. Always fuse battery connections, since a lithium or lead-acid battery can supply hundreds of amps into a short circuit.
Load current × 1.25, rounded up to the next standard rating, and never above the wire's current rating.
The fuse protects the wire. If it is larger, the wire could overheat before the fuse blows.
Slow-blow for motors and capacitive loads with inrush current; fast-blow for electronics.
Minimum fuse = load current × margin; Pick the next standard rating; Fuse rating ≤ wire current rating.
An 8 A steady load with a 1.25× margin needs 10 A, so use a 10 A fuse. 18 AWG wire can carry 16 A in short chassis wiring, so the wire is protected.
Geekobot builds that use it include Solder a fused 12 V to 5 V power board on stripboard, 12 V solar battery monitor: volts, amps and amp-hours, Wi-Fi smart switch and Pico W Wi-Fi switch (MicroPython). Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators