Concept explainer · Intermediate · 4 min read
Brushless Motor KV, Stator Size and Propeller Sizing Explained
By Geekobot Learning Team · Updated 24 Oct 2026
On this page
KV is how many revolutions per minute a brushless motor turns per volt with no load. A 1950 KV motor on a 6S pack (about 22 V) spins at roughly 43,000 RPM unloaded. Higher KV suits small props and lower voltage; lower KV suits big props and higher voltage. Pick the prop first, then the cell count, then a matching KV and stator, and aim for at least 2:1 thrust-to-weight.
Key specs at a glance
- KV
- RPM per volt, unloaded
- No-load RPM
- KV x battery voltage
- Stator code
- 2207 = 22 mm diameter, 7 mm height
- 5 in freestyle
- About 1700 to 1950 KV on 6S, 2300 to 2600 KV on 4S
- 3 in
- About 3000 to 4500 KV on 3S to 4S
- 7 in long range
- About 1300 to 1500 KV on 6S
- Minimum thrust-to-weight
- 2:1 to fly; 4:1 or more for sporty flying
This part can carry many amps. Use wire thick enough for the current, put a fuse close to the battery, check that connectors are rated for the load and give drivers and motors room to cool. A short at these currents melts wires in seconds.
What KV really tells you
KV is a speed constant: with no load, RPM = KV x voltage. It also tells you about torque: a low-KV motor has more turns of thinner wire and produces more torque per amp, so it can swing a larger, heavier prop efficiently. A high-KV motor spins small props fast. KV is not a measure of power. Two motors with the same KV can produce very different thrust depending on stator size, magnets and build quality.
Reading motor size numbers
Motor names such as 2207, 2306 or 2806.5 describe the stator: the first two digits are the diameter in millimetres, the last two the height. A wider stator gives more torque and quicker response; a taller one gives more top-end power. The volume of the stator is a good rough guide to power. Small whoop motors use names like 0802 or 1103.
Matching props, cells and KV
| Craft | Prop | Cells | Typical motor | Typical KV |
|---|---|---|---|---|
| Tiny whoop | 31 to 40 mm | 1S | 0702 to 0802 | 15,000 to 25,000 |
| 2.5 to 3 in cinewhoop / toothpick | 2.5 to 3 in | 3S to 4S | 1404 to 1505 | 3000 to 4500 |
| 5 in freestyle / racing | 5 to 5.1 in | 4S | 2207 / 2306 | 2300 to 2600 |
| 5 in freestyle / racing | 5 to 5.1 in | 6S | 2207 / 2306 | 1700 to 1950 |
| 7 in long range | 7 in | 6S | 2806.5 / 2807 | 1300 to 1500 |
| 10 in and larger, camera or survey | 10 to 15 in | 4S to 6S | 3110 to 4114 | 400 to 900 |
- Tiny whoop
- Prop:
- 31 to 40 mm
- Cells:
- 1S
- Typical motor:
- 0702 to 0802
- Typical KV:
- 15,000 to 25,000
- 2.5 to 3 in cinewhoop / toothpick
- Prop:
- 2.5 to 3 in
- Cells:
- 3S to 4S
- Typical motor:
- 1404 to 1505
- Typical KV:
- 3000 to 4500
- 5 in freestyle / racing
- Prop:
- 5 to 5.1 in
- Cells:
- 4S
- Typical motor:
- 2207 / 2306
- Typical KV:
- 2300 to 2600
- 5 in freestyle / racing
- Prop:
- 5 to 5.1 in
- Cells:
- 6S
- Typical motor:
- 2207 / 2306
- Typical KV:
- 1700 to 1950
- 7 in long range
- Prop:
- 7 in
- Cells:
- 6S
- Typical motor:
- 2806.5 / 2807
- Typical KV:
- 1300 to 1500
- 10 in and larger, camera or survey
- Prop:
- 10 to 15 in
- Cells:
- 4S to 6S
- Typical motor:
- 3110 to 4114
- Typical KV:
- 400 to 900
Propeller numbers: diameter, pitch and blades
A prop labelled 5x4.3x3 (or 5143) is 5 inches in diameter, has 4.3 inches of pitch (how far one turn would move it forward in a solid medium) and has three blades. More pitch and more blades give more thrust and grip in the air but draw more current and make the motor hotter. Always check the motor maker's thrust table, which lists thrust, current and efficiency for specific props and voltages. Keep the ESC's current rating above the highest current in that table.
Thrust-to-weight: a quick sizing check
Add up the all-up weight (frame, electronics, battery, camera). Multiply by the thrust-to-weight ratio you want and divide by the number of motors. Example: a 650 g 5 inch quad at 8:1 needs 650 x 8 / 4 = 1300 g of thrust per motor, which a good 2207 1950 KV motor on 6S with a 5 inch tri-blade can produce. A slow camera platform is happy at 2:1 to 3:1. See drone parts explained and LiPo packs for drones.
Try it: Motor power torque calculator
Change the values and the diagram and results update as you type.
Common mistakes to avoid
- Putting a 4S-rated high-KV motor on 6S; it over-revs, overheats and can burn out the ESC.
- Choosing KV first and the prop later.
- Ignoring the thrust table and using an ESC rated below the motor's peak current.
- Using props too large for the motor so it cannot reach full speed and overheats.
- Assuming higher KV means a better or more powerful motor.
Frequently asked questions
What does KV mean on a brushless motor?
RPM per volt with no load. A 2300 KV motor on 14.8 V (4S) spins at about 34,000 RPM unloaded.
Is higher KV better?
No. Higher KV suits smaller props or lower voltage; lower KV suits bigger props or higher voltage. The right KV depends on the prop and battery.
What KV motor for a 5 inch drone?
Around 2300 to 2600 KV for 4S, or 1700 to 1950 KV for 6S, with a 2207 or 2306 stator.
What does 2207 mean on a motor?
The stator is 22 mm wide and 7 mm tall. Bigger numbers mean a larger, more powerful motor.
Can I use the same motor on 4S and 6S?
Only if the maker rates it for both. A motor designed for 4S will spin far faster on 6S and can overheat; a 6S motor on 4S feels slow.
Parts for this guide
Calculators
Terms in this guide
Projects that use it
Put this into practice: 1 step-by-step build in our project library uses parts from this guide.
Keep learning
Sources
- Motor manufacturer thrust test data (T-Motor, iFlight, BrotherHobby)
- Brushless DC motor theory: speed and torque constants
Written by the Geekobot team from manufacturer datasheets. Always check the datasheet for the exact part and variant you buy.




