Buying guide · Beginner · 3 min read
LiPo Batteries for Drones
Cell Count, C Rating, Capacity and Care
By Geekobot Learning Team · Updated 24 Oct 2026
On this page
A drone LiPo is described by cells in series (S), capacity (mAh) and discharge rating (C). Each cell is 3.7 V nominal and 4.2 V full, so 4S is 14.8 V and 6S is 22.2 V. Match S to your motors, pick capacity for flight time and weight, balance charge at 1C, store at about 3.8 V per cell, and land before 3.5 V per cell.
Key specs at a glance
- Cell voltage
- 3.7 V nominal, 4.2 V full (LiHV 4.35 V), 3.0 V absolute minimum
- Common packs
- 1S whoop, 3S to 4S small quads, 6S for 5 to 7 inch
- C rating
- Max current = C x capacity in Ah (marketing numbers are optimistic)
- Connectors
- XT30 up to about 30 A, XT60 up to about 60 A, XT90 for larger craft
- Charge rate
- 1C is safe; some packs allow 2C
- Storage
- 3.80 to 3.85 V per cell
A shorted, over-charged or damaged lithium cell can get very hot and catch fire. Use a protection board or BMS, never short the terminals, charge on a non-flammable surface and do not leave a charging pack alone. Throw away cells that are swollen or dented.
Reading a LiPo label
A pack marked 6S 1300 mAh 120C XT60 has six cells in series (22.2 V nominal, 25.2 V full), stores 1.3 Ah, claims it can deliver 120 x 1.3 = 156 A, and uses an XT60 connector. The thin multi-wire plug is the balance lead (JST-XH), which lets the charger measure and equalise each cell. Real sustained current capability is usually much lower than the C number; compare packs by brand reputation, internal resistance and weight rather than by C rating alone.
Choosing cell count and capacity
| Craft | Cells | Capacity | Connector |
|---|---|---|---|
| Tiny whoop (65 to 75 mm) | 1S (3.7 V, often HV) | 300 to 550 mAh | BT2.0, PH2.0, A30 |
| 2.5 to 3 in | 3S to 4S | 450 to 850 mAh | XT30 |
| 5 in freestyle | 4S or 6S | 1300 to 1800 mAh (4S), 1100 to 1500 mAh (6S) | XT60 |
| 7 in long range | 6S | Li-ion 6S 3000 to 4000 mAh packs or LiPo 1800 to 2200 mAh | XT60 |
| Camera and survey drones | 4S to 12S | 5000 mAh and up | XT90, AS150 |
- Tiny whoop (65 to 75 mm)
- Cells:
- 1S (3.7 V, often HV)
- Capacity:
- 300 to 550 mAh
- Connector:
- BT2.0, PH2.0, A30
- 2.5 to 3 in
- Cells:
- 3S to 4S
- Capacity:
- 450 to 850 mAh
- Connector:
- XT30
- 5 in freestyle
- Cells:
- 4S or 6S
- Capacity:
- 1300 to 1800 mAh (4S), 1100 to 1500 mAh (6S)
- Connector:
- XT60
- 7 in long range
- Cells:
- 6S
- Capacity:
- Li-ion 6S 3000 to 4000 mAh packs or LiPo 1800 to 2200 mAh
- Connector:
- XT60
- Camera and survey drones
- Cells:
- 4S to 12S
- Capacity:
- 5000 mAh and up
- Connector:
- XT90, AS150
LiPo or Li-ion pack?
LiPo packs deliver very high current and suit aggressive flying. Li-ion packs built from 18650 or 21700 cells hold far more energy per gram but deliver less current, so they give long, gentle flights on 7 inch and larger long-range builds. Never charge a Li-ion pack with LiPo settings above its rating, and treat both chemistries with the same care. See the lithium batteries guide.
Charging, storage and safety
- Balance charge every time, at 1C (1.3 A for a 1300 mAh pack) unless the maker allows more. Use a proper LiPo charger with the balance lead connected, such as an iMAX B6 or a modern smart charger.
- Never leave charging packs unattended, and charge on a non-flammable surface or in a LiPo bag.
- Land at 3.5 to 3.6 V per cell resting; going below 3.0 V damages the cells.
- Store at 3.80 to 3.85 V per cell using the charger's storage mode if you will not fly within a day or two. Full packs left for weeks swell.
- Retire puffed, dented or hot packs. Discharge them fully with a dedicated discharger, then take them to an e-waste or battery collection point. Never puncture or bin a charged pack.
- Carry spare packs in a fireproof bag, with connectors covered.
Try it: Battery life calculator
Change the values and the diagram and results update as you type.
Common mistakes to avoid
- Choosing by C rating alone.
- Leaving packs fully charged for weeks.
- Flying until the quad drops, discharging cells below 3.0 V.
- Charging without the balance lead.
- Using a puffed pack 'just for one more flight'.
Frequently asked questions
What does 4S mean on a LiPo battery?
Four cells in series: 14.8 V nominal and 16.8 V fully charged.
What does the C rating on a LiPo mean?
The claimed maximum discharge current as a multiple of capacity. A 1500 mAh 100C pack claims 150 A. Real-world capability is usually lower.
What is LiPo storage voltage?
About 3.80 to 3.85 V per cell. Store packs at this level when you will not use them for more than a day or two.
How long should I charge a LiPo?
At 1C, a full charge from empty takes about an hour. A pack landed at 3.6 V per cell usually takes 45 to 60 minutes.
Can I use a 6S battery on 4S motors?
No. The motors will spin much faster than designed and can overheat along with the ESC. Match the battery to the motors and ESC rating.
Parts for this guide
Calculators
Terms in this guide
Projects that use it
Put this into practice: 1 step-by-step build in our project library uses parts from this guide.
Keep learning
Sources
- LiPo cell manufacturer handling and storage guidelines
- IEC 62133 safety requirements for secondary lithium cells
- Charger manuals (balance charging and storage modes)
Written by the Geekobot team from manufacturer datasheets. Always check the datasheet for the exact part and variant you buy.



