How-to · Intermediate · 3 min read
Drone Payloads
Droppers, Gimbals, Spray Tanks, Megaphones and Camera Mounts
By Geekobot Learning Team · Updated 29 Oct 2026
On this page
A payload must fit the aircraft's thrust, battery and centre of gravity. Servo droppers release small loads on a switch channel, brushless gimbals stabilise cameras, spray tanks and pumps suit agriculture frames, and megaphones broadcast sound. Check the weight, power draw and control channel for each item, then test hovering with the payload before a real flight.
Key specs at a glance
- Droppers
- Servo release for 4 to 6 kg class loads
- Gimbals
- 2- or 3-axis brushless with a controller such as BGC or Storm32
- Spray systems
- Tanks from 6 to 30 L, pumps, spreaders, radar mounts
- Audio
- Drone megaphones for announcements
- Mounts
- TPU camera holders and quick-release claws
- Control
- A spare receiver channel or flight controller output
Plan weight and power first
Add the payload weight to the take-off weight and check the thrust-to-weight ratio of your motors and props, as explained in heavy-lift motors. Aim for a hover at around half throttle. Check the battery capacity too: payloads shorten flight time, so use the flight time calculator to estimate it.
Payload types
Match the payload to the job.
| Payload | Use | How it is controlled |
|---|---|---|
| Servo dropper / parabolic release | Drop rescue kits, seed balls, markers | One receiver channel (PWM) |
| Brushless gimbal | Stabilised camera or thermal imager | Own controller, powered from the PDB |
| Spray tank and pump | Crop spraying (agricultural frames) | Flight controller relay output or PWM |
| Granule spreader | Seeds and fertiliser | Motor driver with PWM |
| Megaphone | Announcements, search and rescue | Audio link plus power |
| Camera mounts, quick-release claws | Hold cameras and sensors | None; mechanical only |
- Servo dropper / parabolic release
- Use:
- Drop rescue kits, seed balls, markers
- How it is controlled:
- One receiver channel (PWM)
- Brushless gimbal
- Use:
- Stabilised camera or thermal imager
- How it is controlled:
- Own controller, powered from the PDB
- Spray tank and pump
- Use:
- Crop spraying (agricultural frames)
- How it is controlled:
- Flight controller relay output or PWM
- Granule spreader
- Use:
- Seeds and fertiliser
- How it is controlled:
- Motor driver with PWM
- Megaphone
- Use:
- Announcements, search and rescue
- How it is controlled:
- Audio link plus power
- Camera mounts, quick-release claws
- Use:
- Hold cameras and sensors
- How it is controlled:
- None; mechanical only
Wiring a servo dropper
Connect the dropper servo to an unused receiver channel or a flight controller servo output. Power it from a BEC rated for the servo's stall current, not from a weak 5 V pin; see PDB and BEC. Assign a switch on your radio to the channel and set endpoints so the latch fully opens and closes. Test on the bench before attaching the load.
Gimbal basics
A brushless gimbal uses an IMU and motors to hold the camera level. Balance the camera first (the frame should stay in any position with the motors off), then power the controller and tune the PID gains until the camera holds steady. Use dampers to keep vibration out, as in dampers and standoffs.
Agricultural spraying
Spray drones need a frame rated for the full tank weight, a good pump and a flight controller that supports spraying. Add an obstacle avoidance radar and height radar mount for safe low flying, and use a quick-release tank for fast refills. Rinse the pump and tank after each use. Check local rules before spraying; see the Pixhawk and ArduPilot autopilot options.
Try it: Lipo drone flight time calculator
Change the values and the diagram and results update as you type.
Common mistakes to avoid
- Adding a payload without rechecking thrust and flight time.
- Powering a servo dropper from a weak receiver pin.
- Flying a gimbal that is not balanced.
- Letting liquid slosh without a baffled tank.
- Ignoring local rules for spraying and dropping.
Frequently asked questions
How much payload can my drone carry?
Check total thrust against all-up weight and aim for a hover near half throttle.
Do I need a special flight controller for spraying?
A flight controller with spray support, such as ArduPilot-based agri firmware, makes it much easier.
Can I use a gimbal on a small FPV drone?
Usually no. Gimbals suit larger camera drones.
How do I trigger a dropper?
Map a spare radio switch to its receiver channel.
Are megaphones legal?
Rules vary; check local regulations.
Parts for this guide
Calculators
Terms in this guide
Projects that use it
Put this into practice: 1 step-by-step build in our project library uses parts from this guide.
Keep learning
Sources
- Gimbal controller (Storm32/BGC) documentation
- ArduPilot documentation
- Manufacturer manuals for tanks and pumps
Written by the Geekobot team from manufacturer datasheets. Always check the datasheet for the exact part and variant you buy.






