Shop by category
Shop all componentsYour printer
The steps below show this printer's own numbers from its spec sheet where they matter.
7 steps · about 125 minutes plus print time
Step 1 of 7 · about 15 min
Printers are shipped with the moving parts held still by screws, brackets, foam or cable ties. A lock left in place makes the motors grind on the first move and can bend a rod or strip a belt.
Step 2 of 7 · about 30 min
Many printers come part built: the upright frame, the screen, the spool holder or the filament sensor go on at home. Loose frame screws are a common cause of wobbly, shifted prints later.
Step 3 of 7 · about 5 min
A heated bed draws a lot of current. A loose plug or a wrong voltage setting is a fire and damage risk, so this check comes before the first switch-on.
Step 4 of 7 · about 20 min
The nozzle has to sit a fraction of a millimetre above the bed everywhere. Auto levelling measures the bed at many points and corrects for small dips, but it still needs a clean plate and a correct Z offset.
From the Bambu Lab A2L Combo 3D Printer spec sheet
| Build Plate Material | Flexible Steel Plate |
|---|
Step 5 of 7 · about 10 min
PLA is the easiest first filament: it prints at a low temperature and does not need an enclosure. Using the filament diameter your printer takes (almost always 1.75 mm) matters more than the brand.
From the Bambu Lab A2L Combo 3D Printer spec sheet
Step 6 of 7 · about 15 min
The slicer turns a 3D model into the layer-by-layer moves the printer follows. Starting from the maker's printer profile gives you tested speeds and temperatures.
Step 7 of 7 · about 30 min
The test file that comes with the printer is already sliced with good settings, so a problem with it points to the setup, not to the slicer.
From the Bambu Lab A2L Combo 3D Printer spec sheet
For anything specific to your model, such as assembly drawings, menus and firmware, the maker's own manual is the reference.
Handy to have
Read next
| Included Build Plate | Textured PEI Plate |
|---|
| Supported Build Plates | Textured PEI Plate, Engineering Plate, Cool Plate SuperTack |
|---|
| Maximum Heatbed Temperature | 80°C |
|---|
| Extruder Gear | Hardened Steel |
|---|---|
| Extruder Motor | Servo Extruder Motor |
| Filament Cutter | Built-in |
| Nozzle Material | Stainless Steel |
| Filament Diameter | 1.75 mm |
| Maximum Nozzle Temperature | 300°C |
| Build Volume (L×W×H) | 330 × 320 × 325 mm |
|---|