Shop by category
Shop all componentsYour printer
The steps below show this printer's own numbers from its spec sheet where they matter.
7 steps · about 125 minutes plus print time
Step 1 of 7 · about 15 min
Printers are shipped with the moving parts held still by screws, brackets, foam or cable ties. A lock left in place makes the motors grind on the first move and can bend a rod or strip a belt.
Step 2 of 7 · about 30 min
Many printers come part built: the upright frame, the screen, the spool holder or the filament sensor go on at home. Loose frame screws are a common cause of wobbly, shifted prints later.
Step 3 of 7 · about 5 min
A heated bed draws a lot of current. A loose plug or a wrong voltage setting is a fire and damage risk, so this check comes before the first switch-on.
Step 4 of 7 · about 20 min
The nozzle has to sit a fraction of a millimetre above the bed everywhere. Auto levelling measures the bed at many points and corrects for small dips, but it still needs a clean plate and a correct Z offset.
From the Bambu Lab P2S-Combo 3D Printer spec sheet
| Max Heatbed Temperature | 110 °C |
|---|
Step 5 of 7 · about 10 min
PLA is the easiest first filament: it prints at a low temperature and does not need an enclosure. Using the filament diameter your printer takes (almost always 1.75 mm) matters more than the brand.
From the Bambu Lab P2S-Combo 3D Printer spec sheet
| Extruder Type | PMSM Servo Direct-Drive |
|---|---|
| Nozzle Diameter | 0.2 / 0.4 / 0.6 / 0.8 mm |
| Filament Diameter | 1.75 mm |
| Number of Extruders | 1 |
| Supported Filaments | PLA, PETG, ABS, ASA, TPU, PET, PA, PC, PVA, PLA-CF, PETG-CF, ABS-GF, ASA-CF, PA6-CF, PA6-GF, PAHT-CF, PPA-CF, PET-CF |
| Max Hotend Temperature | 300 °C |
Step 6 of 7 · about 15 min
The slicer turns a 3D model into the layer-by-layer moves the printer follows. Starting from the maker's printer profile gives you tested speeds and temperatures.
From the Bambu Lab P2S-Combo 3D Printer spec sheet
| Connectivity | USB, Wi-Fi |
|---|
Step 7 of 7 · about 30 min
The test file that comes with the printer is already sliced with good settings, so a problem with it points to the setup, not to the slicer.
From the Bambu Lab P2S-Combo 3D Printer spec sheet
| Build Volume (L×W×H) | 256 × 256 × 256 mm |
|---|
For anything specific to your model, such as assembly drawings, menus and firmware, the maker's own manual is the reference.
Handy to have
Read next