Shop by category
Shop all componentsYour printer
The steps below show this printer's own numbers from its spec sheet where they matter.
8 steps · about 140 minutes plus print time
Step 1 of 8 · about 10 min
Liquid resin irritates skin and eyes and can cause allergies that get worse with every contact. Uncured resin must never touch bare skin, and the fumes need fresh air.
Warning: never pour liquid resin or used IPA down the drain. Let it cure in sunlight first, then dispose of it as solid waste.
Step 2 of 8 · about 10 min
The screen, the build plate and the vat are packed with foam and film. A forgotten piece of foam under the vat can crack the screen when the plate comes down.
Step 3 of 8 · about 5 min
Step 4 of 8 · about 15 min
Step 5 of 8 · about 10 min
Step 6 of 8 · about 15 min
Step 7 of 8 · about 60 min
Step 8 of 8 · about 15 min
For anything specific to your model, such as assembly drawings, menus and firmware, the maker's own manual is the reference.
Handy to have
Read next
3D printing · resin printer setup
A heated bed draws a lot of current. A loose plug or a wrong voltage setting is a fire and damage risk, so this check comes before the first switch-on.
The plate must press flat on the screen for the first layers to stick. Some printers come pre-levelled or level themselves; others use the paper method.
Resin settles in the bottle, and an overfilled vat spills when the plate comes down.
From the Anycubic Photon Mono M7 Pro 3D Printer spec sheet
| Resin Compatibility | High-speed, water-washable, standard, ABS-like, and plant-based resins |
|---|
Resin printers read a file made for their own screen, so the slicer must know your exact model. Your spec sheet lists the slicers it supports.
From the Anycubic Photon Mono M7 Pro 3D Printer spec sheet
| Connectivity | USB |
|---|---|
| Supported Software | Anycubic Photon Workshop |
Each resin needs its own exposure time. The printer's own test file and an exposure test print show whether your times are right before you spend hours on a real part.
A print straight from the printer is coated in liquid resin and still soft. Washing removes the resin and curing under UV makes the part hard and safe to handle.