How-to · Intermediate · 3 min read
Drone Telemetry Radios
SiK 433 MHz, CUAV P8/P9 and Long-Range Data Links
By Geekobot Learning Team · Updated 29 Oct 2026
On this page
A telemetry radio is a pair of modems: one on the aircraft (sky unit) wired to the flight controller's telemetry UART, and one on the ground connected to a PC or phone. They carry MAVLink so Mission Planner or QGroundControl can show live data and send commands. Use matching firmware and frequency on both, mount antennas away from carbon and check your country's rules.
Key specs at a glance
- Basic kits
- SiK 433 MHz pair, about 100 mW
- Long range
- CUAV P8 (840-845 MHz) and P9 (902-928 MHz)
- Protocol
- MAVLink, serial 57600 baud typical
- Supply
- 5 V on small kits; wide 3S to 12S on P9
- Ground side
- USB to PC, or phone and tablet adapters
- Range
- Line-of-sight; manufacturer figures are best case
What is in the pair
The sky unit mounts on the aircraft and the base (ground) unit plugs into your PC or phone. Both must use the same frequency band, network ID and baud rate.
| Radio | Band | Notes |
|---|---|---|
| SiK 433 MHz kit (100 mW) | 433 MHz | Cheap and simple; good for short range |
| CUAV P8 | 840-845 MHz | Long-range digital radio with base and sky units |
| CUAV P9 | 902-928 MHz | Wide input voltage; long-range data link |
| 4G modems | Cellular | Beyond line of sight; needs coverage; see 4G modules |
| UWB modules | UWB | Indoor positioning, not telemetry |
- SiK 433 MHz kit (100 mW)
- Band:
- 433 MHz
- Notes:
- Cheap and simple; good for short range
- CUAV P8
- Band:
- 840-845 MHz
- Notes:
- Long-range digital radio with base and sky units
- CUAV P9
- Band:
- 902-928 MHz
- Notes:
- Wide input voltage; long-range data link
- 4G modems
- Band:
- Cellular
- Notes:
- Beyond line of sight; needs coverage; see 4G modules
- UWB modules
- Band:
- UWB
- Notes:
- Indoor positioning, not telemetry
Wiring to the flight controller
Connect the sky unit's TX to the flight controller's RX of a free UART, RX to TX, plus 5 V and ground. In ArduPilot or PX4 set that serial port to MAVLink at the same baud rate. On Pixhawk-style controllers the six-pin TELEM port is plug and play; see Pixhawk and ArduPilot. Do not power a 5 V radio from a rail that sags when the motors start.
Connecting the ground station
- 1Plug the base unit into your computer or an OTG adapter.
- 2In Mission Planner or QGroundControl choose the COM port and the radio's baud rate.
- 3Power the aircraft and wait for the link lights to go solid.
- 4Check parameters, attitude and battery readings in the app.
- 5Use the radio configuration tool to change the network ID and power if needed.
Antennas and range
Mount antennas vertically, clear of carbon fibre and the video transmitter, and use the antenna type that came with the radio. Higher power and better antennas give range but need a clean installation. Range figures printed on products assume ideal line of sight; trees, buildings and terrain cut it a lot. Use the link budget tool for a rough estimate and read antenna choice.
Rules to check
Frequency bands and power limits differ by country. For example 915 MHz parts are meant for the Americas. Check what is allowed where you fly before you buy a band, and never exceed the legal transmit power. See RC receivers for the control link, which is separate from telemetry.
Try it: Link budget fspl calculator
Change the values and the diagram and results update as you type.
Common mistakes to avoid
- Mixing 433 MHz and 915 MHz units.
- Using different baud rates on both sides.
- Putting antennas against carbon plates.
- Powering a radio from a rail that browns out.
- Buying a band that is not allowed locally.
Frequently asked questions
Do I need telemetry if I have a control link?
Not to fly, but it gives live data and lets you change parameters and missions.
Which baud rate do SiK radios use?
57600 is the usual default.
Can I use a phone as the ground station?
Yes with an OTG adapter and QGroundControl.
What range will I get?
It depends on antennas, terrain and power. Treat manufacturer figures as best case.
Is 4G better?
It has no distance limit but depends on coverage and has latency.
Parts for this guide
Calculators
Terms in this guide
Projects that use it
Put this into practice: 1 step-by-step build in our project library uses parts from this guide.
Keep learning
Sources
Written by the Geekobot team from manufacturer datasheets. Always check the datasheet for the exact part and variant you buy.





