555 timer LED flasher
The most famous chip in electronics, blinking an LED about once a second.
Shop by category
Shop all componentsLEDs should be fed a set current, not a set voltage. The LM317 keeps exactly 1.25 V across the resistor between its OUT and ADJ pins, so the current is always 1.25 ÷ R, however the supply voltage moves. With 22 Ω that is about 57 mA, enough for two 5 mm white LEDs in series to glow brightly from a car or solar battery. (Three white LEDs need about 13 V once the LM317's own 3 V drop is added, so use two on 12 V.)
Check your LEDs' current rating before choosing the resistor. A smaller resistor gives more current.
Tick anything you already have and the total updates.
22 Ω sets about 57 mA; 10 Ω about 125 mA (check the LED rating)
Follow the colours: red is power, dark grey is ground, blue is a signal.
6 parts: Adjustable Voltage Regulator (LM317), Through-Hole LED Pack (Pack of 10), Resistor Assortment Kit (30 Values), DC Power Adapter 12V 2A (5.5x2.1mm), Solderless Breadboard (830 points) and Dupont Jumper Wires (40 pcs). Tools: Digital Multimeter and Soldering Station. On this page you can tick the parts you already have and add only the rest to your cart.
It is a intermediate project and takes about 1 hour. The build on this page has 5 steps.
No. It is a hardware circuit with no microcontroller and no code. Build it on a breadboard from the wiring table and steps on this page.
About ₹334 for the parts at the prices on this page, plus tools if you do not have them. Quantity price breaks lower the cost when you build several.
Check your LEDs' current rating before choosing the resistor. A smaller resistor gives more current.
Ideas that reuse this build: LM317 variable power supply and Solar street light controller. They are listed under Take it further on this page.
The most famous chip in electronics, blinking an LED about once a second.
Press once and the light stays on for about 11 seconds, then goes off by itself.
A running light like the one on Knight Rider, made from two classic chips.
Touch two wires with a fingertip and an LED lights: skin current switches a transistor pair.
Learning project. Check every circuit and the datasheet of each part before you power it up.