Automatic dusk-to-dawn light
Lights switch on by themselves at dusk and off again in the morning.
Shop by category
Shop all componentsMost garage remotes, doorbells and RF switches use simple 433 MHz on-off keying. With an HT12E encoder on the transmitter and an HT12D decoder on the receiver, four buttons control four outputs with no programming. You then try an EV1527 learning receiver and a ready-made RF smart switch to see the same idea in finished products.
Anything connected to 230 V mains must be installed by a qualified electrician in a closed, earthed enclosure.
Tick anything you already have and the total updates.
Ready transmitter and receiver boards with HT12E and HT12D
Spare encoder/decoder chips to build your own board
EV1527 receiver that learns a remote
Finished RF switch with remote, for comparison
Programmable sub-GHz transceiver, for when you outgrow fixed encoders
Follow the colours: red is power, dark grey is ground, blue is a signal.
Transmitter: 9 V or 12 V battery as the board marks. Receiver: 5 V regulated.
The address pins differ, or the antenna is missing; fit 17 cm wire antennas at both ends.
HT12D outputs latch until another code arrives with that bit off; that is normal.
Use a straight 17 cm antenna and raise the transmitter's supply within its rating.
No, fixed codes can be recorded and replayed; do not use it for locks.
Yes, D0 to D3 and VT are logic outputs.
It is a full radio chip you configure over SPI, so it can talk to many devices.
6 parts: 433MHz RF Encoder and Decoder Boards (HT12E / HT12D), HT12E / HT12D Encoder-Decoder IC, 5V Relay Module with Optocoupler, 433MHz Learning Code Receiver and Remote (EV1527), Generic 1-Channel RF Wireless Smart Switch w/ 433MHz Remote Control and CC1101 868MHz Wireless Transceiver Module. On this page you can tick the parts you already have and add only the rest to your cart.
It is a beginner project and takes about 2 hours. The build on this page has 5 steps.
About ₹1,309 for the parts at the prices on this page. Quantity price breaks lower the cost when you build several.
Address pins and why both ends must match; Latching versus momentary outputs; How learning-code remotes pair.
Anything connected to 230 V mains must be installed by a qualified electrician in a closed, earthed enclosure.
Ideas that reuse this build: nRF24 wireless link. They are listed under Take it further on this page.
Lights switch on by themselves at dusk and off again in the morning.
A precise thermostat that keeps tropical fish at a steady 25–26 °C.
Starts the pump when the tank runs low and stops it when it is full.
Tap a hidden pad to switch a lamp on or off, even through a wooden desk.
Learning project. Check every circuit and the datasheet of each part before you power it up.