555 timer LED flasher
The most famous chip in electronics, blinking an LED about once a second.
Shop by category
Shop all componentsThe LDR's resistance rises in the dark. With the knob above it and the LDR below, the voltage at their junction rises as the light falls, and once it passes about 0.7 V the transistor switches on and lights the LED. The knob sets how dark it must be. It is the simplest automatic light there is.
Tick anything you already have and the total updates.
Light sensor (the LDR from the module, or a bare LDR)
Follow the colours: red is power, dark grey is ground, blue is a signal.
8 parts: Digital LDR Light Sensor Module – LM393, General Purpose Transistors (Pack), 16mm Rotary Potentiometer 10kΩ (Linear), Through-Hole LED Pack (Pack of 10), Resistor Assortment Kit (30 Values), Battery Holder (AA), Solderless Breadboard (830 points) and Dupont Jumper Wires (40 pcs). Tools: Digital Multimeter. On this page you can tick the parts you already have and add only the rest to your cart.
It is a beginner project and takes about 45 minutes. The build on this page has 4 steps.
No. It is a hardware circuit with no microcontroller and no code. Build it on a breadboard from the wiring table and steps on this page.
About ₹203 for the parts at the prices on this page, plus tools if you do not have them. Quantity price breaks lower the cost when you build several.
Ideas that reuse this build: LM358 dark detector and Arduino night light. They are listed under Take it further on this page.
The most famous chip in electronics, blinking an LED about once a second.
Press once and the light stays on for about 11 seconds, then goes off by itself.
A running light like the one on Knight Rider, made from two classic chips.
Touch two wires with a fingertip and an LED lights: skin current switches a transistor pair.
Learning project. Check every circuit and the datasheet of each part before you power it up.