555 timer LED flasher
The most famous chip in electronics, blinking an LED about once a second.
Shop by category
Shop all componentsTap water conducts a little. A common wire sits at the bottom of the tank and three probe wires hang at 25 %, 50 % and 90 %. When water reaches a probe, a tiny current flows into that transistor's base and switches its LED on. No chip, no code, and it works for years.
Battery power only. Never connect a water probe circuit to mains.
Tick anything you already have and the total updates.
Follow the colours: red is power, dark grey is ground, blue is a signal.
6 parts: General Purpose Transistors (Pack), Through-Hole LED Pack (Pack of 10), Resistor Assortment Kit (30 Values), Dupont Jumper Wires (40 pcs), Battery Holder (AA) and Solderless Breadboard (830 points). Tools: Digital Multimeter and Wire Stripper and Cutter. On this page you can tick the parts you already have and add only the rest to your cart.
It is a beginner project and takes about 1 hour. The build on this page has 6 steps.
No. It is a hardware circuit with no microcontroller and no code. Build it on a breadboard from the wiring table and steps on this page.
About ₹158 for the parts at the prices on this page, plus tools if you do not have them. Quantity price breaks lower the cost when you build several.
Transistors as switches; Water as a conductor.
Battery power only. Never connect a water probe circuit to mains.
Ideas that reuse this build: Arduino tank level ring and Overhead tank pump controller. They are listed under Take it further on this page.
The most famous chip in electronics, blinking an LED about once a second.
Press once and the light stays on for about 11 seconds, then goes off by itself.
A running light like the one on Knight Rider, made from two classic chips.
Touch two wires with a fingertip and an LED lights: skin current switches a transistor pair.
Learning project. Check every circuit and the datasheet of each part before you power it up.