Shop by category
Shop all componentsPower, batteries & solar
The input current is much higher than the output current. A cheap MT3608 module is limited by its switch current, not by its marketing wattage.
D = 1 − Vin × η ÷ VoutI in = Vout × I out ÷ (η × Vin)L = Vin × D ÷ (f × ΔI)C out = I out × D ÷ (f × ΔV)5 V to 12 V at 0.5 A, 400 kHz, 90% efficient: D = 0.625, input current 1.33 A, ΔI = 0.4 A, L = 5 × 0.625 ÷ (400,000 × 0.4) = 19.5 µH, so use 22 µH rated for 2 A or more. Output capacitor at least 7.8 µF.
A boost converter stores energy in an inductor while a switch is on, then dumps it to the output on top of the input voltage. Because power in must equal power out plus losses, the input current is always higher than the output current by roughly the voltage ratio.
That is why a boost module powering a 12 V load from a 3.7 V cell draws several times more current from the battery than the load takes. Check the cell and wires can deliver it, and keep the inductor away from saturation.
It stores energy in an inductor while the switch is on and releases it, on top of the input voltage, when the switch turns off.
Power is conserved, so I in ≈ Vout × I out ÷ (η × Vin). Boosting 3.7 V to 5 V at 1 A draws about 1.5 A from the cell.
Losses grow with duty cycle. Ratios above about 5:1 become inefficient and need special designs.
D = 1 − Vin × η ÷ Vout; I in = Vout × I out ÷ (η × Vin); L = Vin × D ÷ (f × ΔI); C out = I out × D ÷ (f × ΔV).
5 V to 12 V at 0.5 A, 400 kHz, 90% efficient: D = 0.625, input current 1.33 A, ΔI = 0.4 A, L = 5 × 0.625 ÷ (400,000 × 0.4) = 19.5 µH, so use 22 µH rated for 2 A or more. Output capacitor at least 7.8 µF.
Geekobot builds that use it include DIY 18650 power bank, 18650 charging station with USB output, Bike speedometer and trip meter and Microclimates around the school. Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators