LM317 variable power supply
Turn a 12 V adapter into an adjustable 1.25–10 V supply for your experiments.
Shop by category
Shop all componentsThe TP4056 charges an 18650 cell safely from any USB charger and protects it from over-discharge. An MT3608 boost converter lifts the 3.7 V cell to 5.1 V for a USB socket, enough to run an Arduino or ESP32 project for many hours.
Use only protected cells and never short the cell terminals. Do not leave charging cells unattended.
Tick anything you already have and the total updates.
Charges the cell from USB, with protection
Follow the colours: red is power, dark grey is ground, blue is a signal.
6 parts: 18650 Li-ion Rechargeable Cell 2600mAh, 18650 Battery Holder, TP4056 1A Li-ion Charger Module with Protection, MT3608 Mini Boost Converter Module, USB Breakout Board (Type-A female) and Dupont Jumper Wires (40 pcs). Tools: Digital Multimeter and Soldering Station. On this page you can tick the parts you already have and add only the rest to your cart.
It is a beginner project and takes about 1 hour. The build on this page has 4 steps.
No. It is a hardware circuit with no microcontroller and no code. Build it on a breadboard from the wiring table and steps on this page.
About ₹480 for the parts at the prices on this page, plus tools if you do not have them. Quantity price breaks lower the cost when you build several.
Li-ion charging and protection (TP4056); Boost converters.
Use only protected cells and never short the cell terminals. Do not leave charging cells unattended.
Ideas that reuse this build: Add a solar panel. They are listed under Take it further on this page.
Turn a 12 V adapter into an adjustable 1.25–10 V supply for your experiments.
Free power for outdoor sensors: sunlight in, 5 V USB out.
Beeps when the mains goes off at night, so the fridge and the alarm clock do not quietly die.
Touch the probes to any battery up to 50 V and read its voltage in big digits.
Learning project. Check every circuit and the datasheet of each part before you power it up.