Shop by category
Shop all componentsMotors & mechanics
Worst case is the arm held horizontal. Rated servo torque is stall torque; keep continuous load under about 50–70% of it.
T = payload × g × L + arm mass × g × L ÷ 21 kgf·cm = 0.0981 N·mRequired = T × safety factorA 200 g payload on a 15 cm arm weighing 50 g: T = 0.2 × 9.81 × 0.15 + 0.05 × 9.81 × 0.075 = 0.331 N·m = 3.4 kgf·cm. With a safety factor of 2 you need 6.8 kgf·cm, so an MG996R (10 kgf·cm) works.
Torque is force times distance, so a long arm multiplies the load on the servo. The worst case is with the arm horizontal; when it points up or down, gravity adds no torque.
For multi-joint arms, work from the end of the arm backwards: each joint has to carry the payload plus every link beyond it. Lightweight materials, short links and counterweights make the biggest difference.
T = payload × g × L + arm mass × g × L ÷ 2, then multiply by a safety factor of 1.5 to 2.
It carries the whole arm and the payload at the longest distance.
An SG90 gives about 1.8 kgf·cm. That holds 100 g at about 10 cm with no margin, so use an MG996R for heavier arms.
T = payload × g × L + arm mass × g × L ÷ 2; 1 kgf·cm = 0.0981 N·m; Required = T × safety factor.
A 200 g payload on a 15 cm arm weighing 50 g: T = 0.2 × 9.81 × 0.15 + 0.05 × 9.81 × 0.075 = 0.331 N·m = 3.4 kgf·cm. With a safety factor of 2 you need 6.8 kgf·cm, so an MG996R (10 kgf·cm) works.
Geekobot builds that use it include Joystick pan-tilt camera mount, Tilt-controlled servo wand, Automatic chicken coop door and Pico servo controlled by a knob (MicroPython). Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators