555 timer LED flasher
The most famous chip in electronics, blinking an LED about once a second.
Shop by category
Shop all componentsRain water conducts only a little, far too little to sound a buzzer. Two transistors in a Darlington pair multiply the tiny current thousands of times: the first transistor's output drives the second's input. Drops bridging the comb-shaped tracks on the pad are enough to switch the buzzer on.
Tick anything you already have and the total updates.
Follow the colours: red is power, dark grey is ground, blue is a signal.
7 parts: HS-S09-PB Rain Sensor Kit – Analog/Digital Output, General Purpose Transistors (Pack), Active Buzzer Module 3.3–5V, Resistor Assortment Kit (30 Values), Battery Holder (AA), Solderless Breadboard (830 points) and Dupont Jumper Wires (40 pcs). Tools: Digital Multimeter. On this page you can tick the parts you already have and add only the rest to your cart.
It is a beginner project and takes about 45 minutes. The build on this page has 5 steps.
No. It is a hardware circuit with no microcontroller and no code. Build it on a breadboard from the wiring table and steps on this page.
About ₹389 for the parts at the prices on this page, plus tools if you do not have them. Quantity price breaks lower the cost when you build several.
Ideas that reuse this build: Arduino rain alert and Transistor water level indicator. They are listed under Take it further on this page.
The most famous chip in electronics, blinking an LED about once a second.
Press once and the light stays on for about 11 seconds, then goes off by itself.
A running light like the one on Knight Rider, made from two classic chips.
Touch two wires with a fingertip and an LED lights: skin current switches a transistor pair.
Learning project. Check every circuit and the datasheet of each part before you power it up.