555 timer LED flasher
The most famous chip in electronics, blinking an LED about once a second.
Shop by category
Shop all componentsThe 555 in monostable mode is a one-shot timer. A press pulls pin 2 low, the output on pin 3 goes high, and the 100 µF capacitor starts charging through 100 kΩ. When it reaches two-thirds of the supply, the timer ends and the LED goes out. The time is 1.1 × R × C: 1.1 × 100 kΩ × 100 µF ≈ 11 seconds. This is how stair lights and toilet fans used to be timed.
Tick anything you already have and the total updates.
Follow the colours: red is power, dark grey is ground, blue is a signal.
9 parts: NE555 Timer IC (DIP-8), Tactile Push Button Switch, Electrolytic Capacitor, Ceramic Disc Capacitor, Through-Hole LED Pack (Pack of 10), Resistor Assortment Kit (30 Values), Battery Holder (AA), Solderless Breadboard (830 points) and Dupont Jumper Wires (40 pcs). Tools: Digital Multimeter. On this page you can tick the parts you already have and add only the rest to your cart.
It is a beginner project and takes about 45 minutes. The build on this page has 5 steps.
No. It is a hardware circuit with no microcontroller and no code. Build it on a breadboard from the wiring table and steps on this page.
About ₹194 for the parts at the prices on this page, plus tools if you do not have them. Quantity price breaks lower the cost when you build several.
Ideas that reuse this build: 555 LED flasher and 555 timer light. They are listed under Take it further on this page.
The most famous chip in electronics, blinking an LED about once a second.
Press once and the light stays on for about 11 seconds, then goes off by itself.
A running light like the one on Knight Rider, made from two classic chips.
Touch two wires with a fingertip and an LED lights: skin current switches a transistor pair.
Learning project. Check every circuit and the datasheet of each part before you power it up.