Shop by category
Shop all componentsWe picked projects that switch something useful at home, with one sensor or input each, in the order that adds one idea at a time: a light sensor, touch, sound, an infrared remote, a keypad, Bluetooth, Wi-Fi and finally a pump with level sensing. Projects that switch mains wiring are the last step, not the first: build and test them with a 12 V lamp or fan, and use a proper enclosed relay board and an adult or electrician for any 230 V connection.
Lights switch on by themselves at dusk and off again in the morning.
A light sensor switches an LED when the room gets dark. The simplest home automation project and a good first use of an analog input.
Parts, wiring and code →Tap a hidden pad to switch a lamp on or off, even through a wooden desk.
Touch a pad to toggle a lamp, with no mechanical switch. You learn debouncing and how to keep an on or off state.
Parts, wiring and code →Clap twice and the lights come on. Clap twice again to switch them off.
A sound sensor toggles a relay on a double clap. Teaches timing between two events so one loud noise does not trigger it.
Parts, wiring and code →Use any spare TV remote to switch two lights or fans.
Use any TV remote button to switch a relay. You learn to read infrared codes and map them to actions.
Parts, wiring and code →A fan that switches itself on when the room gets hot and off once it cools.
A temperature sensor turns a fan on above a set value. The basic control idea behind every thermostat.
Parts, wiring and code →Enter the PIN and a 12 V solenoid bolt pulls back for five seconds.
Enter a code on a keypad to release a lock. Teaches reading a matrix keypad and storing a code safely.
Parts, wiring and code →Switch four 12 V loads from a phone app, with status sent back.
Switch four outputs from a phone over Bluetooth. A first step towards controlling several appliances from one board.
Parts, wiring and code →Switch a 12 V light, fan or pump from a button on your phone.
A relay behind a web page: open it on any phone on your Wi-Fi and toggle a load. The classic ESP-based smart switch.
Parts, wiring and code →Switches on at dusk by itself, and you can override it from your phone.
The dusk light again, now on Wi-Fi with a manual override from your phone. Shows how to combine automatic and manual control.
Parts, wiring and code →Starts the pump when the tank runs low and stops it when it is full.
Level sensors start and stop a pump so the overhead tank fills by itself and never overflows. A project people really use.
Parts, wiring and code →Yes. An Arduino Uno with sensors and relay modules can switch lights, fans and pumps by schedule, light, temperature, a remote or Bluetooth. For control from a phone over Wi-Fi, an ESP32 or NodeMCU board is simpler because Wi-Fi is built in.
Use an Arduino Uno or Nano for local automation (sensor in, relay out). Use an ESP32 when you want phone control, a web page or MQTT and Home Assistant. See the ESP32 vs Arduino guide for the differences.
Only with care. Learn and test with a 12 V lamp or fan first. For 230 V mains use a properly enclosed relay board, keep the low-voltage and mains sides apart, and have an adult or electrician make the mains connection.
Start with the automatic night light: one light sensor and one LED, no mains. Then try the touch lamp and the temperature-controlled fan before moving to relays and Wi-Fi.
Only basic Arduino code. Each project page has the complete code with comments and a troubleshooting section, so you can upload it first and then change the numbers to see what they do.
Every project page has a parts list with Geekobot products you can add to your cart together, and projects use compatible Uno or Nano boards to keep the cost low.