Shop by category
Shop all componentsPower, batteries & solar
Measure after the battery has rested for about 30 minutes without load or charging. Under load the voltage sags and the result reads too low.
Voltage per cell = pack voltage ÷ cells in seriesCharge % = interpolated from the rest-voltage curveRemaining mAh = capacity × charge %A 3S Li-ion pack resting at 11.7 V is 3.90 V per cell, about 64% full. With a 2000 mAh pack that is about 1280 mAh, or roughly 14 Wh, left.
A lithium cell’s resting voltage falls steadily as it discharges, so the voltage gives a usable estimate of the charge left. A fully charged Li-ion cell rests at 4.2 V, half full is about 3.84 V, and 3.0 V is empty.
Always measure on a rested battery. A battery being used or charged shows a different voltage than its real charge level. For projects, read the pack voltage on an ADC pin through a divider, then average several samples, or use a fuel-gauge IC for better accuracy.
Yes for a rough estimate, as long as the battery has rested for about 30 minutes with no load or charger. Under load the voltage sags and reads too low.
Treat 3.0 V per cell as empty. Most protection boards cut off between 2.5 and 3.0 V; going lower damages the cell.
4.2 V per cell when charged; it settles near 4.1 to 4.15 V at rest.
Voltage per cell = pack voltage ÷ cells in series; Charge % = interpolated from the rest-voltage curve; Remaining mAh = capacity × charge %.
A 3S Li-ion pack resting at 11.7 V is 3.90 V per cell, about 64% full. With a 2000 mAh pack that is about 1280 mAh, or roughly 14 Wh, left.
Geekobot builds that use it include DIY 18650 power bank, 18650 charging station with USB output, Bike speedometer and trip meter and Microclimates around the school. Each has the full parts list, wiring and code.
Results are estimates for design and learning. Check critical designs against the component datasheet. Made by the Geekobot Learning Team. How we write our calculators