555 timer LED flasher
The most famous chip in electronics, blinking an LED about once a second.
Shop by category
Shop all componentsThe 555 runs at about 70 Hz, but only while the button holds its reset pin high. Each pulse moves the CD4017's single lit output one step along. Output 6 is wired back to the reset pin, so it counts 1 to 6 and starts again. Nobody can let go at a chosen moment at that speed, so the result is random.
Tick anything you already have and the total updates.
Follow the colours: red is power, dark grey is ground, blue is a signal.
10 parts: NE555 Timer IC (DIP-8), CD4000 Series CMOS Logic IC (CD4017), Tactile Push Button Switch, Through-Hole LED Pack (Pack of 10), Electrolytic Capacitor, Ceramic Disc Capacitor, Resistor Assortment Kit (30 Values), Battery Holder (AA), Solderless Breadboard (830 points) and Dupont Jumper Wires (40 pcs). Tools: Digital Multimeter. On this page you can tick the parts you already have and add only the rest to your cart.
It is a intermediate project and takes about 1–2 hours. The build on this page has 5 steps.
No. It is a hardware circuit with no microcontroller and no code. Build it on a breadboard from the wiring table and steps on this page.
About ₹207 for the parts at the prices on this page, plus tools if you do not have them. Quantity price breaks lower the cost when you build several.
Ideas that reuse this build: Dice on a matrix and LED chaser with 4017. They are listed under Take it further on this page.
The most famous chip in electronics, blinking an LED about once a second.
Press once and the light stays on for about 11 seconds, then goes off by itself.
A running light like the one on Knight Rider, made from two classic chips.
Touch two wires with a fingertip and an LED lights: skin current switches a transistor pair.
Learning project. Check every circuit and the datasheet of each part before you power it up.