555 timer LED flasher
The most famous chip in electronics, blinking an LED about once a second.
Shop by category
Shop all componentsThe 555 ticks about once a second and the CD4017 lights one of its ten outputs in turn. Diodes act like one-way OR gates: outputs 0 to 3 all feed the red LED, 4 and 9 the yellow, and 5 to 8 the green. So red shows for four ticks, yellow for one, green for four and yellow for one, then it repeats.
Tick anything you already have and the total updates.
Ten 1N4148 or 1N4007 combine the slots into three lights
Follow the colours: red is power, dark grey is ground, blue is a signal.
10 parts: NE555 Timer IC (DIP-8), CD4000 Series CMOS Logic IC (CD4017), Diodes (Pack of 10, 1N4007), Through-Hole LED Pack (Pack of 10), Electrolytic Capacitor, Ceramic Disc Capacitor, Resistor Assortment Kit (30 Values), Battery Holder (AA), Solderless Breadboard (830 points) and Dupont Jumper Wires (40 pcs). Tools: Digital Multimeter. On this page you can tick the parts you already have and add only the rest to your cart.
It is a intermediate project and takes about 1–2 hours. The build on this page has 5 steps.
No. It is a hardware circuit with no microcontroller and no code. Build it on a breadboard from the wiring table and steps on this page.
About ₹212 for the parts at the prices on this page, plus tools if you do not have them. Quantity price breaks lower the cost when you build several.
Ideas that reuse this build: Arduino traffic light model and LED chaser with 4017. They are listed under Take it further on this page.
The most famous chip in electronics, blinking an LED about once a second.
Press once and the light stays on for about 11 seconds, then goes off by itself.
A running light like the one on Knight Rider, made from two classic chips.
Touch two wires with a fingertip and an LED lights: skin current switches a transistor pair.
Learning project. Check every circuit and the datasheet of each part before you power it up.