555 timer LED flasher
The most famous chip in electronics, blinking an LED about once a second.
Shop by category
Shop all componentsWithout its timing capacitor, the 555 becomes a one-bit memory. Pulling pin 2 low sets the output high, and pulling pin 4 low resets it. With pin 6 tied to ground, nothing else changes the output, so the LED stays in whatever state you last chose. This is the idea behind the start and stop buttons on machines.
Tick anything you already have and the total updates.
Follow the colours: red is power, dark grey is ground, blue is a signal.
8 parts: NE555 Timer IC (DIP-8), 2 × Tactile Push Button Switch, Ceramic Disc Capacitor, Through-Hole LED Pack (Pack of 10), Resistor Assortment Kit (30 Values), Battery Holder (AA), Solderless Breadboard (830 points) and Dupont Jumper Wires (40 pcs). Tools: Digital Multimeter. On this page you can tick the parts you already have and add only the rest to your cart.
It is a beginner project and takes about 45 minutes. The build on this page has 5 steps.
No. It is a hardware circuit with no microcontroller and no code. Build it on a breadboard from the wiring table and steps on this page.
About ₹185 for the parts at the prices on this page, plus tools if you do not have them. Quantity price breaks lower the cost when you build several.
Ideas that reuse this build: 555 push-button delay light and Touch lamp switch. They are listed under Take it further on this page.
The most famous chip in electronics, blinking an LED about once a second.
Press once and the light stays on for about 11 seconds, then goes off by itself.
A running light like the one on Knight Rider, made from two classic chips.
Touch two wires with a fingertip and an LED lights: skin current switches a transistor pair.
Learning project. Check every circuit and the datasheet of each part before you power it up.